Storing Water in Plastic Soda Bottles

Storing Water in Plastic Soda Bottles

Follow these steps for storing water in plastic soda bottles.

Thoroughly clean the bottles with dishwashing soap and water, and rinse completely so there is no residual soap.

Sanitize the bottles by adding a solution of 1 teaspoon of non-scented liquid household chlorine bleach to a quart of water. Mix the sanitizing solution in the bottle so that it touches all surfaces. After sanitizing the bottle, thoroughly rinse out the sanitizing solution with clean water.

Fill the bottle to the top with regular tap water. If the tap water has been commercially treated from a water utility with chlorine, you do not need to add anything else to the water to keep it clean. If the water you are using comes from a well or water source that is not treated with chlorine, add two drops of non-scented liquid household chlorine bleach to the water. Let the water stand for 30 minutes before using.

A slight chlorine odor should be noticeable in the water, if not, add another dose of bleach and allow the water to stand another 15 minutes.

Tightly close the container using the original cap. Be careful not to contaminate the cap by touching the inside of it with your finger. Place a date on the outside of the container so you can know when you filled it. Store in cool, dark place.

Water can also be treated with water purification tablets that can be purchased at most sporting goods stores.

Water that has not been commercially bottled should be replaced every six months.

More information on water treatment is available at Red Cross.org.